The Importance of Having a Home Inspection Checklist
At Tweedie Home Inspections we use a mobile inspection software on site that contains this checklist and we add our findings under each category. As you can see in the graphic above, the sum of all these categories should cover every piece of an average home. There are a few less common sections that are not part of the graphic, but we wanted to be as general as possible. Let’s take a deeper look into each piece.
Exterior, Lots & Grounds
The exterior section of the report is where most inspections will start. In this category, we look at the overall condition of the exterior ground level systems. This is one of the most important categories because the exterior systems protect your home from the elements. What we look at includes the following:
- Wall coverings (siding), Flashing, and Trim
- Eaves, soffits, and Fascias
- Doors and Windows
- Decks, balconies, steps, porches etc
- Driveways and walkways
- Grading and drainage
Foundations, Basement, and Crawlspaces
A house’s foundation is the base for the whole home. We do everything we can to find any foundation issues or potential issues with the home. This includes visual inspections of the exterior foundation wall, basement or crawlspace foundations, concrete slab defects, and cracking or settling. Foundation problems can be one of the most expensive repairs so it is important that a good overview is performed. We look at the following categories:
- Foundations, Basements, and Crawlspaces
- Columns or Piers
- Floors and walls
- Basement/Crawlspace insulation
- Crawlspace Vapor Barriers and Openings
Roofing, Attic, and Ventilation
Everything above the house is just as important as below. The roof and attic are some of the most asked about items during an inspection. The roofing material is visually examined during an inspection, and we always enter every attic. This also includes the ventilation of the attic and all the flues and chimneys that penetrate the roofing material. Here is what we look for:
- Roof Coverings
- Chimneys, Flashing and Roof Penetrations
- Gutters and Downspouts
- Ventilation of Attic
- Roof Structure and Attic
- Attic Insulation and Vapor Retarders
Plumbing Systems
Next on our home inspection checklist is the plumbing. During an inspection, we test every fixture, faucet, and drain line in the home. We look for leaks, pressure issues, and known problematic piping material. Water damage is a huge concern when buying a home, so it is important to get a full overview. This also includes the hot water heater systems. Here are the plumbing items we look for.
- Water and Fuel Shut-Offs
- Water Supply Lines
- Fixtures and Faucets
- Toilets and Bidets
- Drain, Waste, and Vent Systems
- Hot Water Systems
- Gas Distribution Systems
Electrical Systems
From the main panel to every outlet in the home, electrical is a big component of the home inspection checklist. There are many different facets of a home’s electrical, and we have run into every scenario. Here are the items we inspect:
- Service Entrance Conductors
- Main and Sub Panels
- Main Disconnect Devices
- Branch Circut Conductors and Overcurrent Devices
- Fixtures and Switches
- Receptacle Operation (Polarity and Grounding)
- Ground Fault Circuit Interrupters (GFCI)
Heating and Cooling Systems
An HVAC system inspection is a major part our home inspection process. We go through both systems, run full operational tests, and do visual inspections of the units themselves. We also look at the thermostat and control devices. Here are a few of the items we look at during a HVAC overview:
- Heating Equipment
- Cooling Equipment
- Chimneys, Flues, and Vents
- Thermostat
- Distribution Systems
- Automatic Safety Controls
Interior Inspection
A home inspection is mostly concerned with bigger ticket items and major systems, but during our inspections, we also note the cosmetic condition of the interior of the home. This would include holes in walls, general flooring issues, or harmful wall covers. This is all documented in our interior section:
- Walls, Ceilings, and Floors
- Doors and Windows
- Counters and Countertops
- Bathroom Tubs and Surrounds
- Venting Systems
Built-In Appliances
All of the permanent appliances in the home are tested during our home inspection. This is a limited evaluation where we run the units look for proper functionality. Below are the appliances we test:
- Dishwasher
- Range/Oven
- Range Hood
- Food Waste Disposer
- Microwave Cooking Equipment
- Refrigerator
- Clothes Washer/Dryer
Garage
If a home has a garage or a sprinkler system, we will always inspect these items. In a garage, we are looking for settling issues and garage door operations. With a sprinkler system, we help identify important characteristics and locations of shut-offs, and we will perform a brief test through all the zones. Here are the categories:
- Garage Walls, Ceilings, Floors
- Garage Doors and Door Openers
Our Home Inspection Checklist Summarized:
As you can see, by following this simple home inspection checklist, we can be confident that no items were missed during our inspection. This allows our inspectors to be thorough, but also efficient when it comes to your next home purchase.
There are also many add-ons that you can get during your home inspection that are not listed including: Radon testing, Well water testing, wood destroying insects and pre listing inspections. These will help you get a better understand of issues that cannot be visually seen.
If you are interested in having Tweedie home Inspections perform your pre-purchase home inspection, you can get more information here.
Follow Us!